This article describes what can happen when a PIC is improperly inserted into a slot on the M10i device: the neighboring PIC can malfunction. The PIC slots on the upper FPC are numbered from 0/0 (zero/zero) through. The M7i and M10i routers are the choice for consolidating multiple services onto a single IP/MPLS Number of PIC Slots. To check PIC status including port information, use the show chassis pic pic-slot # fpc-slot # command. 8 open slots. . M10IBASE-DC Juniper M10i Base Unit 8 Pic Slot Chassis Cooling Midplane 2 Dc Power Supplies 1 Forwarding Engine 1 Routin (Refurbished) ; Was: $ ; Part #. of Gbps per FPC on m10i routers. Does it mean that there is Mbps limitation on each PIC inserted in PIC slot on given FPC? Or is it an. 4 open slots. Figure PIC slot numbers for M7i, M10i, and M20 Figure M7i PIC slot numbering In the SRX and MX. The command output for an M10i router. In these systems, the PIC slot numbering goes from right. Four PIC slots are located in each Flexible PIC Concentrator (FPC). Part Number: M10IBASE. PIC slot numbering in horizontally aligned systems such as the M7i and M10i is a little less standard. Available. M10IBASE-DC Juniper M10i Base Unit 8 Pic Slot Chassis Cooling Midplane 2 Dc Power Supplies 1 Forwarding Engine 1 Routin (Refurbished). slot 3 is used for the fixed Ethernet interfaces.